Descripción

Amplifier Unit, Large Display Amplifier
Model GT2-100P
Output PNP output
Mounting type Panel mount/Screw mounting using optional mounting bracket
Main unit/Expansion unit -
Power supply voltage 20 to 30 VDC, including 10 % ripple (P-P), Class 2
Power consumption Normal 4,500 mW max. (30 V, 150 mA max.)
Power saving (Eco) 3,600 mW max. (30 V, 120 mA max.)*1
Display power Measured value display 6 + 1/2-digit 7-segment LED (red)
Other displays 2-colour, 13-level bar LED display (red, green), indicators (red, green)
Display range -199.999.9 to 199.999.9
Display resolution 0.1 ?m
Sampling rate 1,000 times/sec.
Control input Timing/preset/ reset/bank input No-voltage input
Control output HH/HI/GO/LO/LL PNP open collector, 30 V 50 mA or less*2, residual voltage 1 V or less
Response time hsp (3 ms), 5 ms, 10 ms, 100 ms, 500 ms, 1 s
Environmental resistance Ambient temperature -10 to +50 °C (No freezing)
Relative humidity 35 to 85 % RH (No condensation)
Vibration resistance 10 to 55 Hz, Double amplitude 0.15 mm, 2 hours in each of the X, Y, and Z directions
Materials Main body case: Polycarbonate, Key top: Polyacetal, Front sheet: PET
Power supply / I/O cable Power supply: Terminal block, I/O: 20-pin connector (MIL standard)
Weight Approx. 380 g
*1 For GT2-100 Series, when the maximum number of sensor heads are connected and all units are set to power saving mode. *2 When 2 or more sensor heads are connected, 20 mA or less.
''